After I posted the posts about the k2tog and the k3tog, which were not new but they were buried in the files with the patterns. Anyways, after posting those to tutorials, someone asked about a k2togtbl and what it meant.
Okay, a k2togtbl simply stands for a knit two stitches together (k2tog) through the back loop (tbl). In needle knitting, it means that you have to a decrease, similar to the k2tog. The only difference is that you have to knit the two stitches together through the back loops of the stitches. Knitting them through the back loops creates a Twisted Knit Stitch.
In loom knitting, we don't have to worry about the back loops or front loops since our stitches always sit facing the front with both legs of the stitch facing the front. To create a Twisted Knit Stitch in loom knitting, we e-wrap the peg and knit it with the single stitch. Thefore, to create the k2togtbl, in loom knitting, you will move the stitch from the first peg over to the second peg, then you will ewrap the 2nd peg. Second peg now has three loops on it. Next, you will lift the bottommost two loops up and off the peg. Ta-da!!! The k2togtbl has been created! :)
When you decrease, you are removing stitches from your knitting, making that area narrower.
The most common decrease is known as the k2tog (knit two stitches together).
The k2tog creates a decrease that slants to the right.
How does it need to look: When you do a k2tog, you need the second stitch to stay on top, meaning it needs to remain visible when you knit it.
Let’s create a k2tog as follows: k1, k2tog.
How: Knit peg 1. Move the stitch from peg 2 to peg 3 (the k2tog takes place on these two pegs). Knit peg 3, be sure to lift the two loops off the peg (treat them as one loop).
Move the stitches inwards, and the decrease by 1 stitch has been created.
The SSK, it stands for slip, slip, knit, which translates to loom knitting as, skip, skip, knit. However, there is a small twist in our looming. We can’t translate this directly, you see on needles the stitches sit a certain way and the slipping of them changes their position. On loom knitting, our stitches sit always the same way (be it if we are purling or knitting). Anyways, to do the slip, slip, knit, is a little easier but it takes one extra movement of loops than the k2tog.
The SSK creates a decrease that slants to the left (the opposite of a k2tog).
How does it need to look: When you do a ssk, you need the first stitch to stay on top, meaning it needs to remain visible when you knit it.
Let’s create a ssk as follows: k1, ssk.
How: Knit peg 1. Move the stitch from peg 3 to peg 2 (the ssk takes place on these two pegs). Knit peg 2, be sure to lift the two loops off the peg (treat them as one loop). Move the loop on peg 2 to peg 3. Move the loop from peg 1 to peg 2, and the decrease by one stitch has been created.
Knit peg 1 Lift loop from peg 3 and hold it with your fingers (or put it on the peg to the left). Move the loop from peg 2 to peg 3 Get the loop you are holding and place it back on peg 3. Knit peg 3. Be sure to lift the two loops off the peg (treat them as one loop). Move the stitches inwards and the decrease by one stitch has been created.
These two decreases are usually paired together. I like to knit a few stitches at each side before doing the decreases, this gives the edges a more finished look.